Robinsontc
6/2/2006 10:39:37 AM
Accent 2000 1.5L SOHC
There is a 5 wire connector/assembly going to the MAF sensor. What is the trick or procedure to disconnect this connector -- it does not want to disengage from the MAF assembly.
Any help will be appreciated.
TommyR :)
hyundai tech
6/4/2006 4:18:32 PM
Remove the metal clip using a pic and it will unplug.
Robinsontc
6/5/2006 9:31:57 AM
quote:
ORIGINAL: hyundai tech
Remove the metal clip using a pic and it will unplug.
ok -- sounds good. Thanks for the tip!
TommyR :)
p.s. Have you ever successfully cleaned the MAF sensor?
Also, if the MAF acts up, does the computer have a 'soft-fail' mode for this sensor if you un plut it and try to run the car?
Thanks again.
kevincs
6/16/2006 5:32:17 PM
Hey Tommy,
I may be a bit late, but if you read my post (kevincs) you may get some insight into cleaning the MAF sensor. I'm having a fuel consumption problem, and i've read that the MAF sensor may have a big part to play. I hope it works out for you, but if you havent cleaned the sensor yet maybe you can wait to see if anybody answers my post b4 you begin.
