Just cranks after changing Speed Sensors and...
#1
03-10-2010, 06:40 PM
Just cranks after changing Speed Sensors and...
*** Never mind this post. I found that my battery needed replacement.. duh! ****
I just installed new OEM Input and Output Speed sensors on my 2000 Sonata GLS v6 and when I turn the key the car only cranks.
So I cleaned off the lithium grease I sprayed to battery terminals to prevent the excess carbon build up that had been occurring. Still just cranks. Now I'm wondering if it was the LIQUID black tape I globed on to a few locations where I noticed that the existing insulation (black tape) did not cover the colored wires as they enter the plastic clip connections. 
I also globed some on what I recently found out to be the two Oxygen sensors (located at the front of the manifold-just behind the radiator?). Any Help is appreciated.
Carl
I just installed new OEM Input and Output Speed sensors on my 2000 Sonata GLS v6 and when I turn the key the car only cranks.
So I cleaned off the lithium grease I sprayed to battery terminals to prevent the excess carbon build up that had been occurring. Still just cranks. Now I'm wondering if it was the LIQUID black tape I globed on to a few locations where I noticed that the existing insulation (black tape) did not cover the colored wires as they enter the plastic clip connections. I also globed some on what I recently found out to be the two Oxygen sensors (located at the front of the manifold-just behind the radiator?). Any Help is appreciated.Carl
Last edited by cace2002; 03-11-2010 at 04:19 PM. Reason: Found Solution
Thread
Thread Starter
Forum
Replies
Last Post
Merlin Coryell
Hyundai Elantra Touring / i30
4
09-06-2015 04:13 PM
kraig37
Hyundai Accent
1
05-29-2012 07:30 AM
PhoebeAnn
Hyundai XG 350
1
02-16-2012 10:01 AM
omnipotent goku
Hyundai Sonata
3
06-03-2008 09:23 AM
