Fuel Gauge not reading accurately (Full Version)

Hyundai Forum >> Vehicle Line Up >> Hyundai Santa Fe

Fuel Gauge not reading accurately


  

razorback -> Fuel Gauge not reading accurately (3/27/2008 7:57:40 AM)

I just recently purchased a 2004 Santa Fe GLS.  We filled it up right after we bought it and the gauge read full.  The next day we started it and it went to E and the fuel light came on.  Later on that day it read 1/4 tank.  Lately it has been reading 3/4 which could be accurate because we have not put that many miles on the new tank of gas yet.  Any ideas on what could be causing this problem?


  

NovaResource -> RE: Fuel Gauge not reading accurately (3/27/2008 8:35:13 AM)

It could be a bad float in the tank or a bad ground on the wiring.


ken99 -> RE: Fuel Gauge not reading accurately (3/27/2008 10:57:45 PM)

I agree with NovaResource that this could be a bad ground wire connection, especially since the gauge jumps up and down between fills.  Old style floats with leaks would sink and then drain as the gas was used up to refloat briefly when the tank was filled, but that's not the symtoms you see.  Most newer floats are made out of a closed cell foam that I've never seen develop a problem (but all things are possible I suppose).  I'd start by check the ground wiring to the sending unit.


CndRedCoat -> RE: Fuel Gauge not reading accurately (5/5/2008 8:54:06 AM)

I had the same problem with 07 Santa Fe, and they replaced the Sending unit.....

The problem is starting again slowly when I fill up it is not going up again all the way to the Full level.... Another trip to the Dealer...

Hope this time will be good.



madindian1 -> RE: Fuel Gauge not reading accurately (5/7/2008 5:33:36 AM)

the sending unit on the pass side of the tank is not working properly. the car has two of them.


CndRedCoat -> RE: Fuel Gauge not reading accurately (5/8/2008 2:54:10 PM)

Yeah they have two and changed both of them at that time...  I will have to bing it back...


  

Page: [1]

Return to Hyundai Forum home page or view the Full Version of this page.