Cranks over but won''t start

Hyundai Forum Hyundai Classifieds Photo Gallery Member List Calendars Search Contact HF Sponsors
Hyundai Lineup Hyundai News Hyundai Recalls TSBs Timeslips Register Login

Cranks over but won''t start

Printable Version

Hyundai Forum >> Vehicle Line Up >> Hyundai Santa Fe >> Cranks over but won''t start

Page: [1]

Message

<< Older Topic Newer Topic >>

Cranks over but won''t start - 7/9/2008 12:53:46 PM

MannySarria

Posts: 16
Joined: 5/22/2008
Status: offline

I just got my new motor in my 2002 santa fe but when I go to start the ecm fuse blows out? what would cause this??

< Message edited by MannySarria -- 7/11/2008 9:54:12 PM >

Post #: 1

RE: Ecm - 7/11/2008 6:41:04 PM

MannySarria

Posts: 16
Joined: 5/22/2008
Status: offline

There 4 ecm fuses a 15 amp, 2- 20 amp and 1 - 10 amp 10 amp is the one that keeps blowing out any idea.

(in reply to MannySarria)

Post #: 2

RE: Ecm - 7/12/2008 7:46:28 AM

MannySarria

Posts: 16
Joined: 5/22/2008
Status: offline

Well I was affrayed this would be a hard question to get a answer for, well I will keep working on it till I fine that short.

(in reply to MannySarria)

Post #: 3

RE: Ecm - 7/13/2008 3:13:40 PM

MannySarria

Posts: 16
Joined: 5/22/2008
Status: offline

Dose any one no of a site to get the wiring diagram for the 2002 santa fe?

(in reply to MannySarria)

Post #: 4

RE: Ecm - 7/14/2008 6:29:23 PM

MannySarria

Posts: 16
Joined: 5/22/2008
Status: offline

OK I got some progress today I got a ohm meter and fond the sensor on lift side motor in the back I think its a crank sensor, when I unplugged it did not blow out the fuse. But I am not getting any spark??????Do I need a new sensor??? before I can get spark dose that mean sensor is bad???any Help???????

< Message edited by MannySarria -- 7/15/2008 10:25:41 AM >

(in reply to MannySarria)

Post #: 5

RE: Ecm - 7/16/2008 7:27:46 AM

MannySarria

Posts: 16
Joined: 5/22/2008
Status: offline

Well I replaced the crank sensor and it fired right up!!!! It had bare wire causing the short. So I am up and running. You all have a good day.

(in reply to MannySarria)

Post #: 6