throwout bearing ?

Hyundai Forum Hyundai Classifieds Photo Gallery Member List Calendars Search Contact HF Sponsors
Hyundai Lineup Hyundai News Hyundai Recalls TSBs Timeslips Register Login

throwout bearing ?

Printable Version

Hyundai Forums >> Brand Reviews >> Engine & Internal >> throwout bearing ?

Page: [1]

Message

<< Older Topic Newer Topic >>

throwout bearing ? - 12/20/2005 8:05:21 PM

nytelush

Posts: 1
Joined: 12/20/2005
Status: offline

does anyone know if you need a special tool to remove the throwout bearing from the pressure plate on a 2002 elantra 5 speed or if i just need to replace the whole clutch

Post #: 1

RE: throwout bearing ? - 12/21/2005 3:07:59 PM

whiterice

Posts: 21
Joined: 12/15/2005
Status: offline

no the bearing just basically snaps into place and should pull out with a little bit of finesse. i would change the clutch if i was already that deep into it plus its only about 100 for a oem kit. also check the shifter fork (which slides through the throwout bearing) they tend to wear after a while causing the bearing to slide off and misalign. use plenty of grease on contact spots when reinstalling. good luck

(in reply to nytelush)

Post #: 2

RE: throwout bearing ? - 12/29/2005 7:57:32 PM

myhyundairocks

Posts: 1
Joined: 12/29/2005
Status: offline

a pair of snap ring pliers and a really big pry bar usually works for me on these

(in reply to whiterice)

Post #: 3