Check Engine light, no code (Full Version)

Hyundai Forums >> Vehicle Line Up >> Hyundai Accent

Check Engine light, no code

  

rcacs -> Check Engine light, no code (9/30/2006 10:38:10 PM)

HI, just purchased a 2001 Accent GSI (1.6L/std trans/no air). After about a week of driving it, the MIL came on. I scanned it and it shows no codes. I d/c the battery cable to eliminate the light, but it came back on after a few days of driving, again no code comes up on my scanner, and the scan says MIL off.

Any clues out there?

cheers

  
libertyboy17 -> RE: Check Engine light, no code (9/30/2006 10:56:18 PM)

possible short to ground in the intrument cluster. u a tech?

JEANNIE -> RE: Check Engine light, no code (9/30/2006 11:22:22 PM)

I had this problem. First, check to see if there is a hole or leak in the muffler. Next, check for a hole or leak in the flex pipe in the muffler assembly. This is a heavy braided metal pipe. The oxygen sensor is attached to it. It is the sensor which is causing the engine light to go on. A hole in the muffler can be repaired with muffler weld paste or tape. A hole in the flex pipe - it needs to be replaced. Just the flex pipe, not the whole muffler assembly.
Hope this helps.

rcacs -> RE: Check Engine light, no code (10/1/2006 9:56:43 AM)

thanks for the hint, but no holes are present

cheers

  

Page: [1]

Return to Hyundai Forum home page or view the Full Version of this page.