Can't get engine out (accent)

Hyundai Forum Hyundai Classifieds Photo Gallery Member List Calendars Search Contact HF Sponsors
Hyundai Lineup Hyundai News Hyundai Recalls TSBs Timeslips Register Login

Can't get engine out (accent)

Printable Version

Hyundai Forums >> Vehicle Line Up >> Hyundai Accent >> Can't get engine out (accent)

Page: [1]

Message

<< Older Topic Newer Topic >>

Can't get engine out (accent) - 5/14/2007 7:20:26 PM

jchait

Posts: 1
Joined: 5/14/2007
Status: offline

Hi everybody,
I'm trying to swap 1.5L 12 valve engine on my 1998 Hyundai Accent. The engine is on the hoist and as far as I can tell is ready to go out.
It is actually separated from the transmission (automatic) by about 1/2" you can actually see the flywheel. But the crankshaft pulley hits on the body.
Do I need to take this pulley out?. Do I have to loose the transmission?
Thanks in advance.

I have taken out other engines on the past, but Chevy's 350 on rear wheel drive cars. But this is the first time on a transverse front wheel drive.

Thanks in advance

Jaime

Post #: 1

RE: Can't get engine out (accent) - 1/29/2008 8:20:05 PM

fluffypinkkittey

Posts: 5
Joined: 1/29/2008
Status: offline

yes. 99% of teh time with transverse motors you have to remove teh trans. ^_^ i did it on my mk3 jetta, with a 2x4 and a 99 cent strap wrench. it is the proper way to do it. ofcourse. there is always that 1%... that usually ends up breaking something.

(in reply to jchait)

Post #: 2

RE: Can't get engine out (accent) - 1/29/2008 9:08:36 PM

ken99

Posts: 519
Status: offline

I'm not that familiar with the 98 Accent, but most engines on newer front wheel drive cars are dropped out the bottom with the tranny attached on a sub-frame. Once the half-axles are removed and the wiring and cables are disconnected, it usually only takes the removal of four bolts and the subframe can be lowered on jacks or with a hoist. Taking the engine out the top may be the hard way to go.

< Message edited by ken99 -- 1/29/2008 9:09:12 PM >

(in reply to fluffypinkkittey)

Post #: 3

RE: Can't get engine out (accent) - 1/30/2008 12:19:48 PM

madindian1

Posts: 274
Joined: 12/26/2007
Status: offline

all you have to do is remove the crank and water pump pulley. don't loosen trans mounts.

_____________________________

if i'm not doing **** at work i will help you

(in reply to ken99)

Post #: 4