Hyundai Alternator (Full Version)

Hyundai Forum >> Vehicle Line Up >> Hyundai Accent

Hyundai Alternator

  

tinkapark -> Hyundai Alternator (8/20/2007 10:35:49 PM)

Hello All,

My alternator died in my 2000 Hyundai Accent, so I took on the project of replacing it myself. I have it installed fine, but the only problem is I had to remove the mounting arm/bracket that holds the alternator in place. There are a few pieces and I'm not sure how to put it back together, and how to screw it back into the frame. There is the curved piece, and a small suqare piece that has holes in it where bolts pass through. Could someone take a picture of this bracket/arm so I can have a guide as how to put it back together?

  
Doohickie -> RE: Hyundai Alternator (8/21/2007 6:01:04 AM)

Maybe this will help:

GENERATOR
COMPONENTS[image]http://www.hmaservice.com/GRAPHICS/EB/EBDA135A.gif[/image]
REMOVAL
Disconnect the negative terminal from the battery and disconnect the radiator fan connector and condenser fan connector.

[image]http://www.hmaservice.com/GRAPHICS/EB/EBDA035B.gif[/image]
Remove the radiator mounting bolts

[image]http://www.hmaservice.com/GRAPHICS/EB/EBDA035C.gif[/image]
Loosen the belt tension adjusting bolt and remove the mounting bolt. Then, raise the vehicle.

[image]http://www.hmaservice.com/GRAPHICS/EB/EBDA035D.gif[/image]
Disconnect the generator connector and remove the B+ terminal cable.

[image]http://www.hmaservice.com/GRAPHICS/EB/EBDA035E.gif[/image]
Remove the belt and detach the generator mounting bolt and nut. Then, remove the generator assembly while raising the radiator.

[image]http://www.hmaservice.com/GRAPHICS/EB/EBDA035F.gif[/image]

  

Page: [1]

Return to Hyundai Forum home page or view the Full Version of this page.