Heater control not working properly (Full Version)

Hyundai Forums >> Vehicle Line Up >> Hyundai Elantra

Heater control not working properly

  

hatda02 -> Heater control not working properly (9/3/2007 5:56:27 AM)

Sometime last year my heater speed control stopped working. 0 for off of course still works fine. 1,2,3 speed setting does nothing. 4 for max works fine. I was told by a few people the heater control unit right below the radio has the resistor in it and replacing this should fix the problem. I picked up a used one and still have the same problem. Of course the used one could be bad (it was a low milage car), but I'm not so sure.

If I put my ear down in the passenger side foot area and turn the heater control to 1, I can hear the blower unit make a 'click' like it is getting a signal.

Any ideas on what I could test for? I'm at the point where I think it could be the blower motor.

Thanks ahead of time!
Dave

  
Doohickie -> RE: Heater control not working properly (9/3/2007 4:35:02 PM)

I'm guessing it's the Blower Resistor, but it sounds like you already tried that.  The connector for it is labeled "I24" in this picture:

[image]http://www.hmaservice.com/GRAPHICS/E3/E3KC303G.jpg[/image]

For reference here are the schematics out of the Hyundai service manual:

[image]http://www.hmaservice.com/GRAPHICS/E2/E2KC339A.gif[/image] 
[image]http://www.hmaservice.com/GRAPHICS/E2/E2KC339B.jpg[/image] 
[image]http://www.hmaservice.com/GRAPHICS/E2/E2KC339C.gif[/image] 
[image]http://www.hmaservice.com/GRAPHICS/E2/E2KC339D.jpg[/image]

[image]http://www.hmaservice.com/GRAPHICS/EQ/EQKA008A.jpg[/image]

hatda02 -> RE: Heater control not working properly (9/3/2007 5:48:37 PM)

Well.....it looks like I was told the wrong part by a couple people including the Hyundai dealer. The part I replaced was what they call the blower switch in the first pic from the SM. They told me the resistor was part of this unit.

At least I know what I need now. Thanks. I'll update after I get it installed.

hatda02 -> RE: Heater control not working properly (9/8/2007 12:44:13 PM)

I got the part today as pictured above (I24). This fixed the problem. The part number I picked up was 97035-3D000 and was about 45 dollars.

I wish I would have looked at the old part first. It looks like just the solder connection popped off. Oh well. It's fixed either way.

Thanks again for your help.

Doohickie -> RE: Heater control not working properly (9/8/2007 6:58:36 PM)

Awesome.... I'm glad it fixed it!

  

Page: [1]

Return to Hyundai Forum home page or view the Full Version of this page.