Dear forum
I have Hyundai Santa fe 2008 suddenly the engine turnd off and try to started it again but didn't start I used OBDII scanner to scan the system its show the errors ( P2106, P1295, P0638, P1690 and P0685) on the attached picture. I checked the fused show 3 fused blows up with labels "sensor" the fuse was 10A and 2*15A fuses. I replaced the fuse and once I one the ignition key the blow up again. Please advise
kind regards

 

As you know by this time , just knowing the codes is only good if you know what to do with them.
I believe you will need to have someone with some electrical background and experience and a schematic diagram to actually see what is on the circuit in question and chase down the problem. Anything else would be flying blind. There is possibly one thing you might consider, and you need to have some background to do this , and that is, do a visual inspection and look for anything that might look out of place. This is a job for an experienced mechanic/tech.

 

Do any one can help to give the wiring diagram for the 3 sensor?
is there any website give the vehicle wiring diagram?

 

If you know which 3 sensors, just unplug them. Install new fuse and see what happens.
If the fuse still blows , it is not a sensor problem , but a wiring problem. There has to be a direct short to ground for the fuse to blow that quick.

Let us know how you make out, thanks.