Balance shaft alignment plug
#1
Balance shaft alignment plug
Hello friends. I am doing a timing belt on my 1995 Hyundai Sonata with a 4 cyl. 2.0 Liter. It was done about 30,000 miles ago and ran rough from day 1. Recently my water pump started leaking so I am doing this one myself and the directions say if you do not have the balance shaft lined up correctly it will cause a vibration. The repair manual just says the alignment plug is on the left side of the block and has an ambiguose picture. Can anyone be more specific. I found some info on the net that says it behind the exhaust manifold but that was on a v 6. I see a hole up there with a set screw in it but do not want to tear the exhaust apart if thats not it. Is the plug in the same spot as the v 6? Thanks for any help. Oh yeah ps. The balance shaft belt looks like it was never changed but I would like to check the alignment anyhow.
#2
RE: Balance shaft alignment plug
you really need to change both timing and balance belt- usally the balance belt breals and takes-out t-belt -the bolt for shaft is by exhaust manifold has 14mm head ( 9/16) if your not metric -take bolt out and stick screrw driver in it is a half shaft-
#3
RE: Balance shaft alignment plug
lighthouse1: The only plug I see there is behind the exhaust manifold. And there is no way I can get a screwdriver back there without dropping the exhaust many, Did you have to take the exhaust manifold out to get to the plug?
Thread
Thread Starter
Forum
Replies
Last Post
wheredoesthisgo
Hyundai Sonata
0
11-24-2007 06:25 AM