cv joint diagram?
#1
cv joint diagram?
Can anyone give me an overlay of what the cv joint diagram looks like and what I will have to deal with? Thanks!
Edit: I own a 1998 Hyundai Tiburon
Another Edit: Or just a DIY guide on how to change a cv joint for the front driver side.
Edit: I own a 1998 Hyundai Tiburon
Another Edit: Or just a DIY guide on how to change a cv joint for the front driver side.
Last edited by CamronTheGreat; 03-31-2010 at 08:19 PM.
#4
Remove wheel
Remove axle nut at center of hub
Remove ball joint nut, crack the side of knuckle at the ball joint to pop joint loose from knuckle, seperate the 2 so you can pull axle stub from hub.
Pop inner joint from drive unit (large screwdriver betwen joint and case works) dont damage the seal when popping axle loose, or when pulling axle out.
Fluid pill likely pour out of opening....
Align splines of new shaft straight into the drive unit (rotate slightly to feel the splines properly aligned), hold joint straight, and use axle shaft and slap the joint into place..
Install outer stub into hub, assemble knuckle to ball joint, tighten all.
Correct the trans oil level with proper fluid if you lost any when axle pulled out.
Remove axle nut at center of hub
Remove ball joint nut, crack the side of knuckle at the ball joint to pop joint loose from knuckle, seperate the 2 so you can pull axle stub from hub.
Pop inner joint from drive unit (large screwdriver betwen joint and case works) dont damage the seal when popping axle loose, or when pulling axle out.
Fluid pill likely pour out of opening....
Align splines of new shaft straight into the drive unit (rotate slightly to feel the splines properly aligned), hold joint straight, and use axle shaft and slap the joint into place..
Install outer stub into hub, assemble knuckle to ball joint, tighten all.
Correct the trans oil level with proper fluid if you lost any when axle pulled out.
Thread
Thread Starter
Forum
Replies
Last Post